Introduction: Silac U210 is a Single Pack Urethane Alkyd Resin based on Linseed Oil. They are polymers built up by Urethane linkages containing air drying Polyunsaturated ester groups as substitutes. In effect the modern Urethane oils are a type of Alkyd Resin in which the Dibasic Acid is replaced by a Di-isocyanate. The Lacquers & Coatings based on Urethane varnishes are high-tech film formers, very widely used and are unequalled in properties such as toughness, hardness, durability and rapid drying. Though our “Urethane Resins” are as convenient to use as ordinary Oil modified Alkyds, being Single Pack systems and require the common solvents such as MTO and conventional driers, yet yield surface coatings which are as far superior to those possible with Alkyds or other known media. The free Isocyanate content is also Nil and hence can be used even by an unskilled worker.
Properties: The films of Urethane varnishes exhibit the following properties which are superior to those conventional media.

1)Almost colorless, hence suitable for all shades and colors including pure whites.
2)Very rapid rate of initial drying even at low ambient temperature.
3)Thorough drying & Very tough film.
4)No special solvent required conventional solvent e.g. Mineral Spirits is adequate.
5)Excellent abrasion resistance and scratch hardness.
6)Excellent resistance to chemicals and water.
7)Presence of free NCO is negligible and is completely non-hazardous and absolutely safe for handling even by unskilled workers.
8)Can withstand temperature from +160 to -25°C.
9)Dust repellent and antifungal.
10) Excellent salt spray resistance.
11) Can be processed in the manner similar to those for Alkyds with which all
12) Paint manufacturers are familiar.
13)Ability to cure fast at very low oven temperatures such as 2mts at 150°C, leading to higher rate of production with low energy consumption.

COMPATABILITY: Silac U210 is compatible with all Drying oils, Long and Medium oil Alkyds, Epoxies, Ester gums, Phenolics and Maleics in all proportions and only to a limited extent in Chlorinated resins, Short oil Alkyds and Urea resins.